Bluebeam Revu > Tips & Tricks
Earthwork Volume or grading
MJ_Dirt:
Does anyone have any tricks with Bluebeam to figure out volume with a graded slope? I have a couple of work arounds, but I want something quicker and more efficient.
Bluebeam And Burgers:
If you have a profile section, draw in the area of the cut/fill, then go to the Measurement Panel and give it a depth (into the page). These will give you the volume, update the to Cubic Yards or whatever you want the unit measurement to be.
https://www.youtube.com/watch?v=TsVRg1ikweM&t=5s
MJ_Dirt:
Thank you. I hadn't considered that, but that would work great!
Any ideas if you don't have a profile and only a plan view? Again, with a slope. My thoughts were you could do the top section as a triangle (for the slope) and then below the lowest point on the slope, a volume measure. While this should work, I am know needing to remember that I have two pieces I need to add together.
Bluebeam And Burgers:
You could create custom area measurements with depths that match the contours. The markups list would give you totals.. I might have to do a video and blog post on this one!
MJ_Dirt:
A video would be outstanding!
Navigation
[0] Message Index
[#] Next page
Go to full version