Please login or register.

Login with username, password and session length
Advanced search  

Author Topic: Snapping question  (Read 643 times)

A_Hicks

  • Newbie
  • *
  • Karma: +0/-0
  • Posts: 1
Snapping question
« on: July 09, 2019, 08:36:12 am »

I'm marking up a document with measurements from A to B, I have snap to contents turned on but is there a way to set or limit the angle of the measuring tool?  I have to carefully set it to be in 90 degree increments.  It would speed up the process if I didn't have to carefully set my end point.

Thanks
Logged

W31Andrew

  • Newbie
  • *
  • Karma: +4/-0
  • Posts: 19
Re: Snapping question
« Reply #1 on: July 09, 2019, 04:23:55 pm »

If you hold the shift key as you are applying your measurement it will automatically lock in 45 degree increments.
Logged